Technical Information
| Length | 1200mm |
| Width | 600mm |
| Aluminium Foil Thickness | 50 microns (embossed foil) |
| Compressive Strength | 300 kPa |
| Board Wright | 0.90kg |
| External Diameter of Pipe | 16mm |
Important Information
The heat output of this underfloor heating system must be limited to a maximum supply water temperature of 50 Degrees and a maximum floor surface temperature of 27 C for wooden floors (some wooden floor manufactures allow for a higher temperature but please check with them before using with underfloor heating). Underfloor heating cannot compensate for large heat losses of an inadequately insulated house. Please note that underfloor heating systems can give an approximate heat output of 120W/m2 with ceramic and stone tile coverings and 100W/m2 with wooden coverings (up to 16mm thick). “When mixed floor solutions are being served from the same manifold, a floor probe must be used in the floor solution with the lower maximum supply temperature. This is to limit the temperature in these floor areas and prevent damage to the floor solution and/or floor finish.